News

When it comes to installing cladding, a robust, secure fastening is essential. Most fastening systems use visible screws or nails, which can detract from the appearance of the facade. However, if you prefer an invisible fastening, consider the Pan-Clip from FRÜH Schnellbautechnik. This innovative fastening system was specially developed for rhombus, parallelogram and rhombus profiles made of larch, Douglas fir or spruce and enables quick and easy installation of facade cladding. The Pan-Clip is characterized by its ease of use. It can be professionally attached to a substructure made of battens or frames with a cross-section of at least 25...

When it comes to attaching decking boards, there are many different options on the market. One of them is the inexpensive WPC clips, often offered by unknown manufacturers. But while these clips may seem tempting at first, as they are cheaper than other options, there are several good reasons why you should choose Früh WPC clips. First, Früh WPC clips are made of high-quality materials. They are available in stainless steel and galvanized steel, both with a black coating. These materials are durable and resistant to weathering. In contrast, cheap clips are often made of inferior materials that quickly rust...

The installation of the tongue-and-groove boards

Once the first row of profiled boards is screwed in place, attach the remaining rows by inserting your additional profiled timbers into the groove of the lower row of boards. Repeat this process until the row of profiled boards on the wall is complete.

Next, the boards are further screwed in place using the profile screw claws. To do this, place your profile board claw centrally on the substructure and insert the claw into the groove of your board. Next, the profile board clamps are attached to the wooden substructure. The included screws provide the necessary hold for your invisible wall mounting.

You can then start with the next row of profile boards.

With the DiYrect assembly instructions for the FRÜH plank holder, your new wooden terrace will be a complete success. In this article we will explain step by step how you can screw your terrace invisibly. That Mark the supporting timber or the spacing of the substructure on the back of the decking and screw the plank holders offset. To do this, you must place the plank holder on the stop mandrel and screw in the first screw (5 x 17 mm) through the middle hole and tighten it. Important: Screw only with Tighten torque, in do not overtighten and never pre-drill! When fastening in...

The previously common screwing of profiled wooden claws onto a wooden substructure has proven itself over decades, but is time-consuming and cost-intensive. With the rapid construction track from our supplier Früh Schnellbautechnik GmbH, excellent results are achieved in record time. By simply screwing in the wooden profile claws on the drywall rail, you can now produce wood paneling for walls and ceilings in a flash. Regardless of whether it is profiled boards with a groove on both sides or with a tongue and groove profile, thanks to the wide range of profiled wood and panel clips, we can always offer...